Allison 4th Generation

Test 4th-Generation Transmissions

Use Hicklin' s 4th-Generation Allison Control Console to exercise 4th-generation 1000/2000 and 3000/4000 series transmissions outside the vehicle. These control consoles have the capacity to hold up to four Transmission Control Modules (TCMs). Because of the variety of Allison transmission configurations, it may be necessary to add other TCMs or reprogram existing TCMs to test all the different configurations. These control consoles provide easy access to the TCMs whether you need to reprogram or swap it with a TCM programmed for the transmission under test.

The console is used in conjunction with a manual or computerized (TDAC) dynamometer control console. If using TDAC, the pressure gauges are not necessary on the 4th-generation console and are not included. The 4th-generation console connects to the transmission and is only used to exercise the transmission as it would operate when installed in the vehicle.

WARNING: The control console is ONLY intended for use with transmission dynamometers and should not be connected to a transmission while it is in the vehicle.

The roll-around control console is a self-contained cabinet that comprises the interface components found in a typical vehicle installation. Easily access the Transmission Control Module (TCM) connector through the hinged, self-latching lid. The 20' main connector harness connects the console to the transmission. A diagnostic cable connector is provided on every cable harness where technicians can code the Calibration ID Number (CIN) and interrogate the console TCM for troubleshooting the transmission under test.